18
Top LEDs Replacement
Tools Required:
Phillips-Head Screwdriver
1. Follow the instructions for preparing for service. (Page 11)
2. Remove the 4 screws that secure the LED holder for the defective LED strip.
3. Unplug the defective LED strip.
4. Disconnect the pin connector(s).
5. Remove the LED strip from the holder. (Figure 11)
6. Connect the new LED strip ensuring the inscription “IN” is oriented towards the right.
7. Reinstall the LED holder ensuring the flat side of the lead holder is oriented towards the front.
Replacement Part Procedures
LIN Splitter Board Replacement
Tools Required:
Phillips-Head Screwdriver, Pliers
1. Follow the instructions for preparing for service. (Page 11)
2. Remove the front glass by lifting it up and tilting out, using the suction cups to assist.
3. Remove media and carefully lift the media tray out.
4. Locate the LIN splitter and determine if you can reach the standoff without removing the module. Otherwise remove
the module on the right side behind the module. (Reference page 19)
5. Pinch the standoffs from the splitter board while pulling the board away to release it.
6. Install the new splitter board on these standoffs.
7. Transfer the connections from the defective LIN splitter board to the new board.
8. Reinstall the media and media tray.
9. Reinstall the front glass.
LIN
Splitter
Board
Figure 12
Figure 13