FAAC DAAB DB402, Инструкция по эксплуатации, Страница: 9 / 14

INSTRUCTION MANUAL DAAB VEHICLE DETECTOR DB402
Revision 7 9
Channel list, d-channels
Vehicle loop 1
Note that the display of the d-channels is determined by the setting in C702 for EP105
No. Name Range Factory Setting
d100 Vehicle loop 1 0 – 1 0
0 Disabled
1 Enabled
d101 Loop reading x1 000 - 999
d102 Loop reading x1000 00 - 99
d103 Activation by passing vehicle 000 - 999
d110 Detection limit for a vehicle in the loop 05 - 99 15
d111 Difference between on and off in the loop 00 - 50 03
d120 Loop presence reset 000 and 005-240
minutes
120
d121 Fast loop presence reset 00-99 seconds 00
d131 Compensation for activation from door half motor 1 on the
loop in the closed position
00 - 50 03
d132 Compensation for activation from door half motor 2 on the
loop in the closed position
00 - 50 03
d140 Safety function in closing movement 0 - 4 1
0 Disabled
1 Reverse
2 Stop with automatic restart of automatic closing
3 Stop without automatic restart of automatic closing, wait for new control signal
4 Safety only in open position. Used when the gate passes over the loop in the closing movement.
d141 Safety during run-on time or disengagement angle in closing
movement.
0 – 1 1
0 Disabled
1 Activated according to d140
d142 Safety function in opening movement 0 - 4 0
0 Disabled
1 Reverse to fully closed
2 Stop with automatic restart of automatic closing
3 Stop without automatic restart of automatic closing, wait for new control signal
4 Safety only in closed position. Used when the gate passes over the loop in the opening movement.
d151 Loop-based closing 0 - 1 0
0 Disabled
1 Active
d154 Type of closing 1 - 2 2
1 Close immediately when loop is clear
2 Continue to fully open, then close