F5 Viprion, Руководство по платформе

Страница: 62 / 97

Chapter 6
6 - 4
Connecting the DC power source to the system
After the platform is installed in a rack, you can wire the platform to the DC
power source. When you connect the DC power source, F5 Networks
recommends that you follow the safety requirements defined for your
network operations center (NOC). For additional requirements, see
Guidelines for DC-powered equipment , on page 8-2.
There are two groups of terminals on the back of the chassis. When you
view the chassis from the rear, there is one on the left side and one on the
right side. Each terminal group contains the leads for two power supplies.
• Use the group of leads on the right rear of the chassis labeled PWR 2 and
PWR 1 for power supplies 2 and 1.
• Use the group of leads on the left rear of the chassis labeled PWR 4 and
PWR 3 for power supplies 4 and 3.
Figure 6.2 The terminal block plug
Note
The battery return terminals on the VIPRION system are in an isolated DC
return (DC-I) configuration.