F5 i5000 Series, Руководство по платформе, Страница: 29 / 72

Note: Be sure to route the power cords away from the fan tray so that the cords do not impede access
to it.
• For AC-powered systems, connect an auto locking power cable to the power input panel on all
installed power supplies, and then connect the cable to the power source.
Note: Not all country-specific power cables include a locking feature.
Note: To remove the locking power cord, pull one or both of the power cord locking tabs away
from the power supply.
• For DC-powered systems, connect a DC cable to each power supply and then connect the cable to
your DC mains power source.
4. If you plan to set up device service clustering (DSC
®
) with hard-wired failover capacity, connect the
serial failover cable to the FAILOVER port on each unit.
For more information about configuring failover, see
BIG-IP
®
Device Service Clustering:
Administration .
You can now assign a management IP address to the system, and then license and provision the software.
Optionally, you should run the latest version of the qkview utility. This utility collects configuration and
diagnostic information about your system into a single file that you can provide to F5 Technical Support
to aid in troubleshooting. For more information, see:
support.f5.com/kb/en-us/solutions/public/12000/800/sol12878.html
Configure a management IP address using the LCD
You can use the touchscreen LCD to configure the management IP address. With the management IP
address, you can access the Configuration utility to configure other aspects of the product, such as the
product license, VLANs, and trunks.
Note: When using the LCD to configure the unit, be sure to use the Commit option to save all settings.
1. (Optional) Remove the protective film from the LCD panel using the small cutout on the lower right
corner of the film.
2. Touch the screen to activate the LCD menus.
Platform Guide: i5000/i7000/i10000/i11000 Series
29