F5 i15000 Series, Настройка

Страница: 15 / 28

4. If you plan to set up device service clustering (DSC) with hard-wired failover capacity, connect the
serial failover cable to the FAILOVER port on each unit.
Important: Although the serial failover port is of RJ45 type, the port does not support network
connectivity.
For more information about configuring failover, see BIG-IP Device Service Clustering: Administration
at support.f5.com .
You can now assign a management IP address to the system, and then license and provision the software.
Optionally, you should run the
QKView
utility. This utility collects configuration and diagnostic information
about your system into a single file that you can provide to F5 Technical Support to aid in troubleshooting.
For more information, see
K12878: Generating diagnostic data using the qkview utility .
Configure a management IP address using the LCD
You can use the touchscreen LCD to configure the management IP address. With the management IP address,
you can access the BIG-IP Configuration utility to configure other aspects of the product, such as the product
license, VLANs, and trunks.
Note: When using the LCD to configure the unit, be sure to use the Commit option to save all settings.
1. (Optional) Remove the protective film from the LCD panel using the small cutout on the lower right
corner of the film.
2. Touch the screen to activate the LCD menus.
3. Tap Setup .
The Setup screen displays.
15
Setting Up the i15000 Series Platform