F5 BIG-IP 8950, Руководство по платформе

Страница: 19 / 56

Description Option Number/Letter
Resets the AOM subsystem. In this case, the system is
reset with a hardware reset. Reset AOM subsystem (issues
hardware reset--USE WITH
CARE!) 4
Important: We do not recommend using this option
under normal circumstances. It does not allow for
graceful shutdown of the system.
Powers off the Host subsystem. In this case, TMOS is
powered off. If the Host subsystem is already powered
off, this option powers on the Host subsystem. Power off/on Host subsystem
(issues hardware
shutdown--USE WITH
CARE!) 5
Configures the baud speed for connecting to AOM using
the serial console. AOM baud rate configurator B
Presents a logon prompt for the AOM subsystem. This
subsystem cannot be configured by end users. AOM subsystem login L
Runs the AOM network configuration utility. This utility
enables you to reconfigure the IP address, netmask, and AOM network configurator N
default gateway used by AOM. If you use this option
while connected using SSH, your session will be
disconnected as a part of the network configuration
operation.
Displays information about the platform, including serial
number and MAC address. AOM platform information P
Accessing the AOM Command Menu from the serial console
You can access the AOM Command Menu through the host console shell (hostconsh) using the front panel
serial console.
1. Log on to the serial console.
2. Type the following key sequence:
Esc (
The AOM Command Menu displays.
Setting up Always-On Management SSH access
You can use the AOM Command Menu to set up remote SSH access to the system and then connect remotely
using an SSH client.
1. Log on to the serial console.
2. Type the following key sequence:
Esc (
The AOM Command Menu displays.
3. Type
N
to select the AOM network configuration utility.
4. Configure an IP address and gateway for the AOM subsystem.
19
Platform Guide: 8950