F5 BIG-IP 1600, Руководство по платформе

Страница: 48 / 107

Chapter 4
4 - 4
Working with interfaces
You can perform configuration tasks such as displaying interface status and
settings and setting the media type using the
bigpipe utility.
When using the bigpipe interface command, you can either apply the
command to all interfaces or to a specific interface key (for example, 1.1).
Status and settings for interfaces
From the command line interface, use the following syntax to display the
current status and the settings for all installed interfaces:
b interface show all
Figure 4.2 shows an example of the output you see when you issue this
command on the active unit of an active/standby configuration.
Use the following syntax to display the current status and the setting for a
specific interface:
b interface <interface_key> show
interface speed pkts pkts pkts pkts bits bits errors trunk STP
Mb/s in out drop coll in out
1.1 UP 100 FD 0 213 0 0 0 74.2K 0
1.2 UP 100 FD 20 25 0 0 28.6K 33.9K 0
Figure 4.2 The bigpipe interface show command output