F5 BIG-IP 10000 Series, Руководство по платформе, Страница: 14 / 68

Putting the unit in standby mode
Use the LCD control buttons to put the unit into standby mode.
Hold the X button for four seconds to put the unit in standby mode and power off the host subsystem.
F5
®
recommends that you halt the system before you power off the system in this manner.
Resetting the unit
Use the LCD control buttons to reset the unit.
Hold the Check button for four seconds to reset the unit.
You should only use this option after you halt the unit.
Clearing alerts
Use the LCD control buttons to clear alerts from the LCD screen.
Press the Check button to clear any alerts on the LCD screen.
You must clear any alerts on the screen before you can use the LCD panel.
Indicator LEDs
The behavior of each LED indicates the status of the system.
Status LED
The status LED indicate the operating state of the system.
Description State
System is halted and powered down. off/none
System is running in normal mode. Also indicates that the system is in an Active state
of a device group. green solid
System is running in an impaired mode. The condition is not considered to be
significant enough to be considered an alarm condition. Also indicates that the system
is the Standby member of a device group. amber solid
The system is not under host computer control. This might be due to the host being
halted or in EUD mode, or due to a software or hardware problem that interferes with
the host's control of the LED. amber blinking
(with traffic)
14
The 10000 Series Platform