Instructions for Assembly – EZ HANG Love Seat Wicker Series
Regarding any questions about our products please contact your sales rep. or visit our
website.
www.ezhangchairs.com
Parts and assembly of EZ Hang Love Seat Wicker Series
.
a) Cushion piece (1)
.
b) Cup holders (2)
.
d) Set of spreader bars (2 bars) identical.
.
e) Third spreader bar used to hang foot rests and optional weather cover. This
spreader bar will have holes in different location then the other 2 identical
spreader bars. NOT TO BE USED TO HANG OR SUPPORT LOVE SEAT
IN ANY FASHION. DO NOT HANG THE LOVE SEAT FROM THIS BAR.
.
f) Hardware pack: 8 hex head bolts,8 washers,8 nuts, 8 decorative plastic caps
for nuts,2 eye lags,4 S hooks,1 set chains
Place the 2 S shaped wicker arms about 50”
apart on a flat surface and place the
padded cushion between the upward sloping wicker arms. (Make sure the ropes
are facing upwards.)
Slide the two identical spreader bars through the sleeves on the underside of the
cushion.
Locate and remove the 8 machine bolts, nuts and washers from the hardware
bag. Insert the 8 bolts (2 for each corner of the chair) through the holes on the
spreader bars, lining them with the corresponding holes in the wicker arms.
The back spreader bar located at the top of the cushion where your neck or head
rests should be bolted to the front of the arms. The front spreader bar where your
thigh rests can be bolted to the back side of the arms. You can however bolt both
spreader bars to the front of the arms if you prefer.
Be sure the ropes are not tangled or caught behind the spreader bars. They must
be free and clear when lifting the chair up.
