EZ DUPE Flex PRO SD, Руководство пользователя

Страница: 9 / 18

4. Dual Source Copy + Compare
Two source devices with identical content will be used for this task. One source device is
inserted into source port while the other inserted into the 1
st
target port. Duplicator starts
copy process first and reads data content from the source port; duplicator then starts
compare process after copy is done, and reads data content from the 1
st
target port. By
comparing the copied devices against the second source, it can find out if the source device
has unexpected damage or not, and avoid the waste of time and media for further
duplication. The rest of procedure is the same as regular Copy + Compare procedure.
5. Capacity Check
It will format the target devices to the file format according to the system Setup(please refer
to 7.3Set Type of Format), then sort out target devices based on the capacity threshold
(please refer to 7.4Set Capacity Threshold). Duplicator will display the target device which is
not in the capacity range and its red LED will flash. Press
▲▼ button to switch between the
target devices with smaller capacity to check the data status. The ones without capacity
issue will not be displayed to expedite the capacity check process. If Format and or Capacity
Check is failed, the red LED will stay solid on.
Compare with the source on
the 1
st
target port
ENT
Copy from the source on
the source port
D_COMP
：
31100M
P
：
0 F
：
0 15%
4. Dual Source Copy +>
Ready device: 3
D_Copy:3 1100M
P
：
0 F
：
0 10%
Put source devices into Source
port and 1
st
target port
Result: 02 : 25
Pass
：
3 Fail
：
0
Final result
ENT
Format
：
4
P
：
0 F
：
0 0%
Format Process
ENT
5.
Capacity>
Ready device: 4
Sure to format?
YES
Insert source and target devices
Result: 00 : 02
Pass
：
4 Fail
：
0
Final result
8