EZ-ACCESS Pathway Stair System, Инструкция по сборке, Страница: 15 / 15

- 15 -
5.2. Tighten the thumb screw in the foot.
5.3. Use the hole in the foot as a template to drill
an 11/32” or 3/8” hole through the support tube and
secure foot to support tube using a 5/16”
-
18 x 3” long hex bolt & 5/16”
-18 locknut.
WARNING! YOU MUST INSTALL THE NUT AND BOLT LISTED IN STEP 5.3 ABOVE, OR A
DANGEROUS SITUATION MAY RESULT.
5.4.
Tighten the 3/8”
-16 set screws in the riser corner pocket securely (FIG.16).
5.5. Insert a 1-
1/2” square tube plug into the top of each support tube.
5.6. Repeat steps 5.1 to 5.5 on the opposite side.
6.
FREESTANDING STAIR USE & INSTALLATION
WARNING! WHEN USING AS A FREESTANDING STAIR, YOU MUST SECURELY ANCHOR
ALL FOUR FEET, OR A DANGEROUS SITUATION MAY RESULT. CONTACT YOUR LOCAL
CONTRACTOR FOR EXPERT ADVICE AND ASSISTANCE.
6.1. If the Pathway Stair System is freestanding (i.e., not attached to a platform, deck, or porch) ALL
FOUR FEET (TWO AT THE BOTTOM AND TWO AT THE TOP) OF THE STAIR MUST BE
SECURELY ANCHORED (anchors not provided). Select the appropriate anchor for the ground
condition where the stair is installed. Use the holes closest to the front of the stair for the two
bottom feet and any one of the three holes in the two polymer feet at the top (FIG. 17).
FIG. 17