EZ-ACCESS Passport PL44SP3651, Руководство по установке

Страница: 23 / 68

Page | 23
8.
OPTIONAL EQUIPMENT – WIRELESS REMOTE
8.1. OVERVIEW
8.1.1. The wireless remote allows remote operation of the VPL from a suitable location and can be used
in conjunction with the call/send control option. Multiple FOB transmitters allow VPL operation
from various locations, for instance, inside a home or vehicle.
Do not allow unauthorized persons to use the VPL or wireless remote.
To prevent unwanted electrical discharge, always turn off VPL power, unplug VPL AC
power cord, and unplug the white ground wire from battery before installing the antenna.
8.2. The wireless remote antenna cable is available in two lengths:
8.2.1. 108 ” for standard VPL heights up to and including 72” .
8.2.2. 199 ” for standard VPL heights over 72” .
8.3. INSTALLATION
8.3.1. If connected, disconnect the 12-volt AC power cord from the receptacle.
8.3.2. If connected, disconnect the white wire (there is only 1 white battery wire) from the battery
terminal.
8.3.3. Refer to the wireless remote parts list (FIG. 8.1).
8.3.4. Refer to GAMA receiver (“receiver”) mounting location (FIG. 8.2) and place receiver on VPL ’s lower
rail.
8.3.4.1. Hold receiver steadily. Insert a marker into the holes where the two #8-32 thread
cutting screws will go and mark the VPL frame.
8.3.4.2. Use a #20 drill bit to drill a pilot hole for the screws.
8.3.4.3. Place receiver’s 5/16” ring terminal (on black ground wire) under receiver and
secure with two #8-32 thread cutting screws (FIG. 8.3).
FIG. 8.1
FIG. 8.2