-23-
3
）
Connecting terminal for alarm
（
1
）
Disassemble supplied connector for alarm and solder the
lead wire of external device as shown in the right picture.
※
Insulate the connector with heat shrinkable tube so that the
terminal won't be short-circuited.
※
Do not use terminal with winding up the wire (without soldering) .
（
2
）
Set up disassembled connector.
（
3
）
Connect the plug of the connector for alarm to
「
Alm Out
」
.
Lead wire
Terminal
Heat shrinkable tube
Connector for outputting alarm
Soldering
※After soldering, shrink the heat shrinkable
tube by drier.
To output device
＋
−
G（Earth）
Insert
Banana jack
Recorder side
Lead wire
Rec Out
2
）
Connecting terminal for outputting recorder
Wire required for connecting recorder are not
supplied with this product. Prepare the wire that
has appropriate size and length.
3. Setting and using fluorescent lamp
（
1
）
Remove 2 screws on the front side of the ceiling of the
chamber and loosen other 2 screws a little bit.
（
2
）
Attach 2 screws to the holes of fluorescent lamp and
tighten them by cross-slot screwdriver with holing the
lamp.
（
3
）
Now the lamp is fixed with 2 screws that were removed
before.
（
4
）
Connect the plug of the lamp to the outlet on the right
side of the chamber.
（
5
）
Turning on the fluorescent lamp switch (refer to P. 8,9)
on the right side of the unit while the power switch is
turned on can light up the lamp.
Connect the
connector to the
outlet in the
chamber.
（1）Remove 2 screws and loosen other 2 screws
at the ceiling of the chamber
（2）Setting fluorescent lamp
（3）
※
Since the outlet for LTI-E has three terminals, do
not use setting adapter.
※
Fluorescent lamp (optional accessory) is used for
checking sample and etc. Please turn the lamp off
except for these cases. Also, fluorescent lamp unit
(LU-1000) is available for incubating device.
