8
TROUBLESHOOTING
Problem
Vacuum:
will not turn on/
no power
Does not pick up debris
Suction not strong
Canister full indicator light
is on
Sensor does not activate
Debris at Inlet before unit is
powered on
Status indicator light
blinking
1. Not firmly plugged in
2. is in off position
3. Pre-Motor Filter is not in correct
position
4. No power in wall plug
5. Blown house fuse or
tripped circuit breaker
1. Dirt inlet is blocked
2. Canister is full
3. Debris may be too large
for Inlet
1. Pre-Motor Filter may be dirty
1. Canister is full
1. is not in Auto mode
1. is not in Auto
mode
1. sensors have been
shut off for 30 seconds which
caused power to the motor to
be shut off
1. Press Power button to turn off EyeVac Air
2. Clean path of dirt Inlet
3. Empty Canister
4. Clear large debris
1. Press Power button to turn off
2. Clean filters when needed
1. Press Power button to the Auto position
1. Press Power button to the Manual position
2. Activate manually
1. Press Power button to turn off
2. Empty the Canister
3. Clean all filters
1. Press Power button to the power off
2. Check Pre-Motor Filter, and Exhaust
Filter to ensure they are clean.
3. Clean sensors with warm water and Q-tip.
DO NOT USE ALCOHOL OR SOAP.
1. Plug in firmly
2. Press Power button to Manual or
Auto position
3. Ensure that Pre-Motor Filter is locked and flush
with Canister in place
4. Check house fuse or circuit breaker
5. Have a qualified licensed electrician replace
house use or reset circuit breaker.
6. Remove Canister to check switch inside cavity
above Pre-Motor Filter is positioned
Possible Cause
Possible Solution
If your problem is not listed,
please contact Customer Support.
EyeVac Plus.indd 8
EyeVac Plus.indd 8
4/1/21 2:57 PM
4/1/21 2:57 PM
