extronics iWAP200, Инструкция по установке и эксплуатации

Страница: 13 / 23

Operating Manual
13
3.1.6 Fibre Ethernet Input
Important When connecting the access point via a fibre connection do not use
any of the two Ethernet inputs of connectors.
To obtain greater wired link distances the iWAP200 can be shipped with an optional
fibre module. The fibre module will be connected directly to the access point, the user
should attach the fibre cable directly to the fibre module. The fibre cable should be
fed through the Ethernet cable gland.
If a multimode fibre option has been specified the connection is mage via a “ST”
connector.
If a s ingle mode fibre option has been specified, the connection is made via a “SC”
connector.
Important The fibre cable must enter the iWAP200 enclosure via a cable gland, it
therefore may be necessary to terminate the Fibre cable, with the correct
connector, from within the enclosure after the cable has been fed
through the cable gland.
3.1.7 Thermostat Control
The thermostats are currently not user configurable. The default configuration is for
the heaters to be turned on when the internal ambient temperature is between -20
o
C
and +30
o
C and for the fans/wireless hardware to be on above -20
o
C.
3.1.8 Fitting the antennas
•
Connect the antennas to the correct the N type connector on the outside of the
enclosure (see Diagram 3.1.1). Make sure to only connect antennas which are
intended to be used at the frequency required (i.e. either 2.4GHz or 5.8GHz
antennas).
•
Depending on the options ordered some of the N-types may have been
replaced with blanking plugs or surge arrestors.
•
If the version ordered contains both a mesh router and access point; the mesh
router and access point should be setup in software to run at 5.8GHz and
2.4GHz respectively. The iWAP200 will be wired in this way when delivered.
•
The iWAP200 may be used with any antenna (all antennas will however, need
to be assessed to the BS EN 60079-11:2007 standard and approved by
Extronics for use with the iWAP200). It is recommended to use the Extronics
iANT200 series of antennas as these have already been pre-approved for use
with the iWAP200.