Setup Guide — YCS SW2 A
The Extron
®
YCS SW2 A is a two input, dual output
video and audio switcher with transcoding and
auto-input switching capabilities and digital time base
correction (TBC). This guide provides basic instructions
for setting up and operating the switcher.
Installation
Step 1 — Mount the unit
Mount the switcher on a rack shelf, furniture, or a projector pole mount if desired.
Step 2 — Connect video inputs
Connect composite video or S-video source devices to the Video, S-video, or
both input connectors.
Step 3 — Connect video outputs
Connect video output devices to the Video (composite), S-video, or both
output connectors.
Step 4 — Connect audio inputs
a.
Wire the RCA input connectors to audio sources as shown
in the diagram at right.
b.
Connect the left stereo channels of the audio sources to
one or both white RCA Audio Input connectors.
Connect the right stereo channels of the audio input
sources to one or both red RCA Audio Input connectors.
Step 5 — Connect audio outputs
a.
Wire the RCA audio output connectors to audio output devices as
shown in step 4a, above.
b.
Connect the left stereo audio channels of the output devices to one
or both white RCA Audio Output connectors.
Connect the right stereo audio channels of the output devices to
one or both red RCA Audio Output connectors.
Step 6 — Wire the power connector (optional)
If using a different external power supply from the one provided with the YCS, wire the
included 2-pin captive screw connector to your power supply as shown below.
C
The power supply must not be permanently fixed to the building or similar structures.
The power supply must not be located within environmental air handling spaces or the
wall cavity.
The installation must be in accordance with the applicable provisions of the
National
Electrical Code ANSI/NFPA 70, Article 725 and the Canadian Electrical Code,
Part 1, Section 16.
The power supply must be located within the same vicinity as the Extron A/V
processing equipment in an ordinary location, Pollution Degree 2, secured to a podium,
desk, or equipment rack in a dedicated closet.
(Continued on reverse side)
Tip (+)
Sleeve ( )
AUDIO
1
INPUTS
OUTPUT
2
L
R
R
L
VIDEO
VIDEO
S-VIDEO
INPUTS
OUTPUT
1
2
SECTION A–A
Ridges
Smooth
Power Supply Output Cord
A
A
3/16” (5 mm) Max.
