The Extron
®
Annotator and
USP 507 have a series of
optional output boards.
These boards are:
•
Scan converter board
•
HD-SDI board
•
DVI-D board
•
Scaler board (with DVI-I). Any one of these boards
mounts in the optional output slot, above the RGB and
MTP ports, at the rear of the Annotator or USP 507.
For full device operating details, refer to either the
Annotator User Guide or the USP 507 User Guide, both
available at
Annotator and USP 507
Optional Output Boards
•
Installation Guide
Continued on side 2.
1
HDSDI
OUT
DVI-D
OUT
LO-
RES
OUT
R-Y/
R
C
Y/
G
VID
B-Y/
B
Y
SCALED
DVI-I
OUT
Installing a Board in the Annotator or USP 507
1.
Turn off the unit, and remove the power cord. Repeat for all connected
devices.
2.
Remove eight cover-securing screws from the top and three from each side.
Slide the top cover off. Retain the fourteen screws.
3.
At the rear optional output slot either:
a.
Remove the two securing screws
a
from either side of the blank plate
and lift the plate away. Retain the screws
.
NOTE:
Re-use the screws to
secure the new output
board in place. Retain
the blank plate.
Or,
b.
If a board is already installed in the output slot, remove any cables and
the two screws
a
. Then remove the retaining screw that secures it to the
post on the device motherboard. Carefully lift the board away from the
socket. Retain all the screws.
4.
Remove the new board from its box and anti-ESD bag,
holding the board by the front frame or board edge.
5.
Turn the board over so the header sockets face up. Insert
the supplied connector pins into the sockets on the board.
6.
Turn the board over again so the connector pins are now
facing down. Carefully align the pins with the appropriate sockets on the
unit motherboard, and push the board firmly down into the sockets.
7.
Secure the board to the frame with the two retaining screws
a
and to the
post on the motherboard using either the original or the supplied screw.
8.
Replace the cover, securing it with the fourteen screws removed in step
2
.
9.
Reconnect any input and output devices and connect to the new board.
10.
Connect any control devices.
11.
Power on the Annotator or USP 507, and all the connected devices.
Header Socket
RGB/R-Y,Y,B-Y
MTP
LO-
RES
OUT
R-Y/
R
C
Y/
G
VID
B-Y/
B
Y
1
1
