Reset to Factory Defaults
This mode resets all IP settings and TLC settings to factory defaults and removes all
configurations. It allows you to start over with configuration and uploading.
NOTE:
The factory configured passwords for all accounts on this device have been set to
the device serial number. If the device is reset to factory defaults, the passwords revert to
extron
. Passwords are case sensitive.
Activation
To reset the unit to all factory default settings:
1.
Hold down the
Reset
button for about 9 seconds until the Power LED blinks three times
(once at 3 seconds, again at 6 seconds, and again at 9 seconds).
2.
Release and press
Reset
momentarily (for <1 second) within 1 second. Nothing happens if
the momentary press does not occur within 1 second.
Result
Reset to Factory Defaults mode performs a complete reset to factory defaults (except the
firmware):
•
Does everything Reset All IP Settings mode does.
•
Removes TLC user interface layout and configurations.
•
Resets all TLC settings to factory default.
Enable or Disable the DHCP Client
This mode toggles between DHCP enabled and DHCP disabled. This can also be carried out
from the
screen of the
Setup
menu (see page 17) or Toolbelt (see the
Toolbelt Help
File
).
Activation
To enable or disable the DHCP client for the LAN port:
1.
Press the
Reset
button five times (consecutively).
2.
Release the button. Do not press the button within 3 seconds, following the fifth press.
Result
•
If DHCP was enabled, it is now disabled. The Reset LED blinks three times.
•
If DHCP was disabled, it is now enabled. The Reset LED blinks six times.
NOTES:
•
DHCP toggle mode is supported on firmware version 3.0 or higher.
•
By default DHCP is off and the unit uses a static IP address.
•
When you disable DHCP, the unit reverts to using the previously‑set static IP address.
TLC Pro 526M, 726M, and 1026M Series TouchLink Pro Control Systems • Reference Material
36
