1
IMPOR
TANT
:
Go to
for th
e
complete user guide and installation
instructions befor
e connecting the
product to the power sou
rce.
www
.extron.com
TLP Pro 1225MG and TLP Pro 1525MG • Setup Guide
Overview
The Extron TLP Pro 1225MG and TLP Pro 1525MG are wall-mounted touchpanels with capacitive, edge-to-edge glass
touchscreens. The TLP Pro 1225MG has a 12.1 inch screen with a 1280x800 resolution. The TLP Pro 1525MG has a 15.6 inch
screen with a 1366x768 resolution. Both touchpanels are ideal for any AV applications requiring large touchpanels with flexible
mounting options and fully customizable interfaces. This guide provides instructions for experienced installers to mount and install
these touchpanels. For more complete details, see the
TLP Pro 1225 and TLP Pro 1525 Series User Guide
at
Setup Checklist
Get Ready
Download and install the latest version of the following software:
GUI Designer
— for designing layouts for Extron TouchLink
®
Pro touchpanels and third party touch interfaces
Global Configurator
®
Professional or Global Configurator Plus
— for setting up and configuring the control processor
and touchpanel
Toolbelt
— provides device discovery, device information, firmware updates, configuration of network settings, system
utilities, and user management for TouchLink Pro devices
Global Scripter
®
— provides an integrated development environment for Extron control systems programming.
NOTE:
All four software programs are available from
.
Obtain the following network information from your network administrator:
DHCP status
(on or off). If DHCP is off, you also require:
IP address
Subnet mask
Gateway
Username
— This can be either
admin
or
user
.
Passwords
— The factory configured passwords for all accounts on this device have been set to the device serial number.
Passwords can be changed during configuration. Passwords are case sensitive.
NOTE:
If the device is reset to default settings, the passwords are reset to the default password, which is
extron
(for
either
admin
or
user
).
Make a note of the touchpanel MAC address.
Mount and Cable All Devices
ATTENTION:
•
Do not power on the touchpanels until you have read the Attention in the “Power Supply” section of the
TLP Pro 1225
and TLP Pro 1525 Series User Guide
.
•
Ne branchez pas les écrans tactiles avant d’avoir lu la mise en garde dans la section « sources d’alimentation » du
TLP Pro 1225 and TLP Pro 1525 Series User Guide
.
Mount the units. There are several mounting options for TouchLink Pro touchpanels (see
Connect the touchpanel to a Power over Ethernet (PoE) injector (not provided). Extron recommends the PI 140 power injector,
which must be purchased separately (see
Connect the power injector to the LAN and power it on.
An Extron IP Link
®
Pro control processor must be connected to the same Ethernet subnetwork as the touchpanel.
Set up the Touchpanels for Network Communication
Connect the PC that you will use for setup, the control processor, and touchpanel
to the same Ethernet subnetwork
.
Use the
(see page 5) or Toolbelt (see
Toolbelt Help File
) to set the DHCP status and, if necessary, the IP
address, subnet mask, gateway, and related settings for the touchpanel.
Configure the Touchpanels
Create a graphical user interface with GUI Designer (see
GUI Designer Help File
for step-by-step instructions).
Associate functions with the graphical user interface features by configuring (see the
Global Configurator Help File
) or
programming (see the
Global Scripter Help File
) the system. Global Scripter provides an Extron-exclusive Python library
(ControlScript
®
) and Global Scripter modules to get you started.
