Extron electronics TLP Pro 1022T, Руководство пользователя

Страница: 27 / 33

Mounting with a wall box
install BB 710M,
and run the cables.
TLP PRO 1022M
Hold the Touch Panel at a slight angle.
Mount the Touch Panel over the two
hooks on the Mounting Plate.
Add the Mounting Plate.
Align w/ Wall Box.
Mark holes for screws.
Fasten the
Mounting Plate
to the wall
with screws (4).
Fasten the Touch Panel
to the Mounting Plate
w/ Pan Head Screws (2) in
base of Touch Panel.
6
8
4
2
1
Rear View
3
Insert pan head screws
with washers (2) into the
mounting screw slot.
Figure 19. Wall Mounting the TLP Pro 1022M with the BB 710M
1.
Cut a hole in the drywall, 7.70 inches (19.56 cm) wide x 6.00 inches (15.24 cm)
high, and install the BB 710M, as described in the BB 710M Installation Guide (see
www.extron.com ).
2. Place the metal mounting plate against the wall, mark the four mounting holes, and drill four
pilot holes.
3.
Fasten the mounting plate to the wall with four #10 screws (not provided).
4. Insert the two provided Phillips pan head #6-32 x ¾ inch length screws with washers in the
mounting screw slot.
5.
Run and connect cables to the back of the touchpanel (see
Rear Panel Features
on
page 5).
6. Hold the touchpanel at a slight angle and lower the notches at the top of the back panel
over the hooks of the mounting plate.
7. Swing the bottom of the touchpanel inwards so that it lies flat against the mounting plate
with the tongue at the bottom of the mounting plate sitting in a groove in the bottom of the
touchpanel.
8.
Fasten the touchpanel to the mounting plate with the mounting screws.
TLP Pro 1022 Series • Mounting 19