TeamWork 400 Kit • Installation Guide (Continued)
4
Installation
Install the Cable Pass-through Cassette Module and Show Me Cables
Detailed instructions are in the
Cable Cubby Setup Guide
.
Extron recommends the layout shown to the right with cable
pass-through module to the left of the power module.
NOTE:
The figure to the right shows the US power
module. Power modules for other countries look
different.
INPUT
(to source device)
Top of Cable Cubby
OUTPUT
(to switcher)
Bottom of
Cable Cubby
Share Button
Three-conductor
pigtail for contact
closure and tally
ATTENTION:
•
The end with the button and LED connects to the input
devices and must come out of the top of the Cable
Cubby.
•
Le bout avec le bouton et la LED se connecte
aux appareils d’entrée et doit ressortir du haut du
Cable Cubby.
•
The end with the three-conductor pigtail connects to
the switcher and must come out of the bottom of the
Cable Cubby.
•
Le bout avec le mini câble à trois conducteurs se
connecte au sélecteur et doit ressortir du bas du
Cable Cubby.
1.
Assemble the cable pass-through cassette module as
shown in the diagram to the right.
2.
Insert the cable cassette module into the Cable Cubby from
underneath and secure them in position with the provided
#4-40 Phillips head screws and star washers.
Install the Power Modules in the Cable Cubby
Insert the power module into the Cable Cubby from underneath
and secure the power modules in position with the provided
#4-40 Phillips head screws and star washers.
WARNING:
Possible electric shock:
To ensure
good electric grounding, you must use the star
washers with the screws.
AVERTISSEMENT:
Risque de choc électrique:
Afin d’assurer une mise à la terre correcte, vous
devez fixer les modules d’alimentation au Cable
Cubby à l’aide de vis et de rondelles en étoile.
Power Module
Cable Pass-through Cassette Module
125V~ 1
2A MAX
TO
TAL
Secure the modules
using two of the
provided screws.
Slide the cassette modules
into the Cable Cubby from
underneath.
1
1
2
2
Insert Show Me
Cables into the
grommet plate.
1
Attach the Trim Plate
to the top of the module,
using the included
screws.
2
Attach the grommet
plate to the bottom
of the module, using
the included screws.
3