Mounting the Speaker
The speaker can be Installed into rigid material (mineral tile, gypsum board, sheetrock, etc.)
or soft material, such as fiberglass.
1.
Insert the speaker through the bottom of the hole in the ceiling tile that was cut in
step 3
on page 3
(
Preparing the Installation Location
) with the wires out of
the way.
2.
Clamp the speaker to the C-ring by using a Phillips screwdriver to tighten the four
locking arms to the C-ring (see figure 10 and the Note below).
NOTE:
The screw hole locations are marked on the
front baffle with a Phillips-head screw symbol. Use
these holes to tighten the locking arms.
Locking arm
screw hole
marking
8Ω
8Ω
64
W
32
W
OF
F
8W
16
W
64
W
32
W
16
W
OF
F
100 V
70
V
Figure 10.
Clamping the Speaker to the C-ring
Tightening the Locking Arms into Rigid Material:
For rigid material use the Opti-Torque
TM
indicator ring as a tightening guide.
ATTENTION:
•
To avoid damaging the speaker locking arms, do not overtighten the four
screws.
•
Ne pas trop serrer les quatre vis pour éviter d’endommager les bras de
verrouillage de l’enceinte.
SF 26CT LP User Guide • Installation - Single Installer
9
Содержание SoundField XD SF 26CT LP
Страница 6: ...SF 26CT LP User Guide Contents vi...