Extron electronics RGB to DVI Scaler RGB-DVI 300, Руководство пользователя

Страница: 55 / 68

RGB-DVI 300 and RGB-HDMI 300 • Serial Communications
4-17
Signal Processing Products Control Program
All the features of the RGB-DVI 300 and RGB-HDMI 300 that
can be controlled by SIS commands, can also be controlled by a
computer that is running the Signal Processing Products Control
Program (SPPCP).
Installing the SPPCP
The control program is available on the disk provided with the
RGB-DVI 300 or RGB-HDMI 300. It can also be downloaded
from the Extron Web site ( www.extron.com ).
The minimum system requirements for installing the program
on the computer are:
Operating System — Microsoft
®
Windows
®
2000 or later
CPU — Intel
®
Pentium
®
II processor with a 400 MHz clock speed
Hard Disk space — 10 MB
Memory — 256 MB of RAM
Device connection — Serial COMM Port
When the installation program has been located on the Extron
Software Product disk or the Extron Web site, double click to
start it and follow the on-screen instructions to download and
install the program.
Running the SPPCP
The computer can be connected to the video scaler using a 9-pin
D female connector from the PC to either the RS-232 captive
screw connectors on the rear panel or the Config port on the
front panel of the RGB-DVI 300 or RGB-HDMI 300.
To start the program, click on the desk-top icon (shown
at right) or click on the Windows
Start
button and select
All Programs
>
Extron Electronics
>
Signal Processing
">
Signal Processing Products Control Program .
First, the "Select Connection Type" dialog box opens:
Select the
RS-232 tab
and then select the computer port
(typically
COM1
or
COM3
) and the baud rate to use (the default
rate is 9600).