RGB-DVI 300 and RGB-HDMI 300 • Installation
2-5
Through-desk mounting
Mount the unit through a desk or podium using the optional
Extron MBD 129 through desk mounting kit (part # 70-077-02) as
follows:
1
.
Remove rubber feet if these have been attached.
2
.
Attach the brackets to the scaler, using the four 4-40 screws
provided; leave the screws slightly loose.
Through-desk mounting
3
.
Hold the unit in position, under the mounting surface.
Mark the location of the four screw holes and the
mounting hole to be cut in the table.
4
.
Remove the table material. Test the fit by inserting the
front of the device through the hole. If necessary, use a
rasp or coarse file to enlarge the hole.
5
.
Drill four pilot holes, each 3/32" (2 mm) in diameter by
1/4" deep (6.3 mm) deep.
6
.
Attach the brackets to the mounting surface, using the four
#8 wood screws provided with the kit.
7
.
Slide the device in or out until the front panel is flush with
the table surface. Tighten the screws installed in step 2.
8
.
If these screws are inaccessible to a screwdriver, mark the
location of the unit relative to the brackets, remove the unit
and brackets, tighten the screws, and replace the unit.
Содержание RGB to DVI Scaler RGB-DVI 300
