PVS 407D • SIS Communication and Control
20
NOTE:
The factory configured passwords for all accounts on this device have been set
to the device serial number. In the event of a complete system reset, the passwords
convert to the default, which is no password for this device. Passwords are case
sensitive.
Error Responses
When the switcher receives a valid command, it executes the command and sends a
response to the host device. If the unit is unable to execute the command, it returns an error
response to the host.
Error codes
E01
— Invalid input channel
E18
— System/command timed out
E10
— Invalid command
E22
— Busy
E12
— Invalid port number
E24
— Privilege violation
E13
— Invalid parameter
E25
— Device not present
E14
— Not valid for this configuration
E26
— Maximum number of connections
exceeded
E17
— System timed out
E28
— Bad filename or file not found
Error response references
These references in the command and response tables note particular error responses to
that command.
14
= Commands that give an
E14
(invalid command for this configuration) error if sent to a
product whose current configuration does not support the command
24
= Commands that give an
E24
(privilege violation) error if not administrator level
28
= Commands that give an
E28
(file not found) error
SIS Overview
Using the Command and Response Tables
(see page 24) for SIS commands lists the
commands that the switcher recognizes as valid, the responses that are returned to the
host, a description of the command function or the results of executing the command, and
examples of commands in ASCII (Telnet) and URL encoded (web).
NOTE:
Upper and lower case text can be used interchangeably unless otherwise
stated.
ASCII to HEX Conversion Table
•
space
Figure 13.
ASCII to Hexadecimal Character Conversion Table
13
