Labeling the AV Inputs
A sheet of labels is supplied for the installer to label the cables as an aid to easy
identification of the input signal type running from the PVT Wallplates to the switcher.
Once the labels are attached to the cables, the signal type transmitted on any cable can
clearly be identified, enabling correct cable connection during installation.
To label the cables,
1.
Peel off the label corresponding to the cable signal type (HDMI or RGB) and affix it
close to one end of the cable.
NOTE:
Align and press the colored section of the label to the cable first, then
wrap the clear section around the cable, allowing the signal type name to be
easily read.
HDMI/RGB
Figure 5.
Wrap the Label Around the Cable, Colored Part First.
2.
Repeat step 1 for the other end of the cable, using the same label type.
3.
Using the correct label type, repeat steps 1 and 2 as necessary for all signal cables
that are to be connected to the PVS 407D.
4.
Connect the designated input cable to the corresponding input.
Labeling the PVT Faceplates
To help identify the input number and type of signal
that a PVT wallplate sends to the PVS switcher when
the wallplate is installed, a series of small labels are
supplied. A label identifying the transmitted signal type
should be affixed to each decorator-style face plate (top
or bottom) where it can easily be seen after installation.
This aids the user to connect a device corresponding to
the plate transmission signal type, allowing correct input
switching (for example input 1, input 3, and so on) at the
PVS 407D.
Each digital wallplate has two inputs. Up to two wallplates can be connected to the
PoleVault digital switcher. See image below for an explanation of input association.
HDMI/RGB
VGA IN
AUDIO IN
AUDIO IN
HDMI IN
e
AUDIO IN
HDMI IN
IR OUT
G
S
AUDIO IN
HDMI IN
Connect up to two digital wallplates
to PVT IN 1/2 and 3/4 using 1 XTP DTP 24
cable with RJ-45 connectors per wallplate.
PVT HD RGB
PVT HDMI
NOTE:
Any digital wallplate connected to PVT IN 1/2
on the switcher is associated with inputs 1 and 2.
Input 1 is the left audio and video input, and input
2 is the right audio and video input on the
wallplate.
The same is true when connecting to PVT IN 3/4.
Input 3 is the left and input 4 is the right input on
the wallplate.
B
Connect up to two digital wallplates
to PVT IN 1/2 and 3/4 using 1 XTP DTP 24
cable with RJ-45 connectors per wallplate.
HDMI
HDMI
1/2
SIG
LINK
SIG
LINK
3/4
5
6
INPUTS
OUTPUT
PVS 407D
PVT IN
PVT IN
3A MAX
POWER
12V
7
7
7
7
7
7
D
D
D
D
D
D
D
D
Figure 6.
Wallplate to Switcher Input Association
5
6
VGA IN
AUDIO IN
AUDIO IN
HDMI IN
e
HDMI IN #1
RGB IN #2
PVS 407D Switcher • Rear Panel Connections
8
