Extron electronics NAV E 101, Руководство пользователя

Страница: 23 / 80

NAV E 501 and NAV E 101 Encoders • Installation and Basic Operation 15
Reset Mode Comparison and Summary
Mode Activation Result Purpose and
Notes
1
Hold down the recessed Reset button while
applying power to the unit.
NOTE: After a mode 1 reset is
performed, update the unit firmware
to the latest version. Do not operate
the unit firmware version that results
from the mode 1 reset. If you want to
use the factory default firmware, you
must upload that version again (see
Firmware tab on page 36 for details
on uploading firmware).
The unit reverts to the factory default firmware. All user files
and settings, such as IP settings, are maintained.
NOTE: If you do not want to update firmware, or you
performed a mode 1 reset by mistake, cycle power to
the unit to return to the firmware version that was running
before the mode 1 reset (see
About Page on page 56 to
find the firmware version).
Use to return
the unit to the
factory default
firmware version
if incompatibility
issues arise with
user-loaded
firmware.
Har
dwar
e r
eset
4
Hold the Reset button for approximately
6 seconds, until the Reset LED blinks twice
(once at 3 seconds and again at 6 seconds).
Then momentarily press
Reset within
1 second .
Resets all the IP settings without affecting the device
configuration:
• Enables ARP capability.
•
Sets the IP address, subnet address, gateway address, and
port mapping to the factory default.
• Sets the Multicast IP, stream number and device name to the
factory default.
• Turns DHCP on.
The Reset LED blinks three times in succession during the reset.
Enables you to
set IP address
information using
ARP and the
MAC address.
Reset IP (SW)
settings
5
Hold the Reset button for approximately
9 seconds, until the Reset LED blinks three
times (once at 3 seconds, again at 6 seconds,
and then again at 9 seconds). Then momentarily
press
Reset
within 1 second.
NOTE: Reverts the factory-configured
username to admin and password to
extron
.
Performs a complete reset to factory defaults (with the
exception of the firmware):
• Does everything mode 4 does.
•
Resets all settings with the exception of factory firmware.
• Resets all IP options.
• Removes all files from the unit.
•
Removes the initial serial number passwords and sets them
to
extron .
The Reset LED blinks four times in succession during the reset.
For starting
over with
configuration
and uploading
or to replace
events. Same as
the
E ZQQQ }
SIS command
on page 64.
Factory (SW) r
eset
Performing mode 4 and 5 resets
Perform resets of the unit as follows (see figure 9):
1. Use a small screwdriver to press and hold the rear panel Reset button until the rear
panel
Reset
LED blinks either:
• Twice, for an IP settings reset
• Three times for an absolute (factory) reset
Release, then immediately
press and release again.
RESET
RESET
Release, then immediately
press and release again.
6 seconds
9 seconds
Press and
hold
the Reset button.
Press and hold
the Reset button.
Reset LED blinks twice .
Reset LED blinks
three times.
IP Settings
Reset
Factory
Reset
(Mode 4)
(Mode 5)
Figure 9. Resets
2. Release the Reset button and then immediately press and release the Reset button
again. Nothing happens if you do not momentarily Reset within 1 second.