MTP 1500RL 15HD A SEQ • Setup Guide
This guide provides basic instructions for an experienced installer to set up and operate the
Extron MTP 1500RL 15HD A SEQ twisted pair receiver.
For full details, see the MTP 1500RL 15HD A SEQ User Guide, available online at
.
MTP 1500RL Series
POWER
12V
1.0A MAX
MTP 1500RL 15HD A SEQ
OUTPUT
MONO
L
R
AUDIO
RGB
PEAKING
LEVEL
DELAY
RED
GREEN
BLUE
SELECT
ADJUST
MIN/MAX
INPUT
BUFFERED OUTPUT
ON
H
+
V
+
CSYNC
SO
G
VIDEO
END
SP
ARE
MTP
MTP
Installation and Setup
Step 1 — Mounting
Turn off or disconnect all equipment power sources. Mount the MTP 1500RL 15HD A SEQ receiver as required.
Step 2 — Connect input
Connect the RJ-45 cable from an MTP transmitter to the Input port on the MTP 1500RL 15HD A SEQ receiver.
Terminate the cable as shown below right, using the same standard (A or B) at both ends.
Input
Source
MTP Tx
Device
Display
MTP RL Rx
Device
Input
Source
MTP Tx
Device
MTP 1500RL
15HD A Device
Display
1500 feet (457 m) maximum
Transmission distance with
one device before the MTP 1500RL 15HD A SEQ
Transmission distance with
more than one device before the MTP 1500RL 15HD A SEQ
VGA
cable
VGA
cable
TP
cable
MTP 1500RL
15HD A Device
1500 feet (457 m) maximum
VGA
cable
VGA
cable
TP
cable
TP
cable
NOTE:
The transmitter and receiver are designed for and perform best with Extron Enhanced Skew-Free
™
AV cable
terminated in accordance with the TIA/EIA T568A standard. CAT 5 cables are acceptable but less preferable.
Using preterminated and tested cables is also recommended. Cables terminated on site should be tested before
use to ensure that they comply with Category 5 specifications.
Step 3 — Connect outputs
Attach the applicable output cables (video, audio, and buffered output).
a.
High resolution video output — Connect a display device to the 15-pin HD connector (RGB).
b.
Audio connector — Connect an audio device to the 5-pole captive screw connector for mono audio output
1
MONO A
UDIO
2
1
MONO A
UDIO
2
Unbalanced Output
Balanced Output
Do not tin the wires!
Mono output 1-
Sleeve(s)
Mono output 1+
Mono output 2+
Mono output 2-
Sleeve(s)
Mono output 1
Mono output 2
NO GROUND.
NO GROUND.
CAUTION
For unbalanced audio, connect the sleeve(s) to the ground contact.
DO NOT
connect the sleeve(s) to the negative (-) contacts.
c.
Buffered output — Connect up to 5 daisy-chained MTP receivers to this RJ-45 connector.
CONTINUED ON SIDE 2
Pin T568A Wire
Color
T568B Wire
Color
1
White-green
White-orange
2
Green
Orange
3
White-orange
White-green
4
Blue
Blue
5
White-blue
White-blue
6
Orange
Green
7
White-brown
White-brown
8
Brown
Brown
RJ-45 Connector
12345678
Insert Twisted
Pair Wires
Pins: