IPCP 505 • Hardware Features and Installation
10
Front Panel Features
Front panel features are shown below. Most of the features and LED indications are
described and shown in
Rear Panel Features and Connections
on page 12 paired
with the descriptions of the corresponding rear panel ports.
NOTE:
The IPCP 505 must be set up in order to function. See the
based Configuration and Control
section starting on page 20 and the
Global
Configurator Help File
for information about Global Configurator, which you must use
to set up the unit.
IPCP 505
1
2
3
4
5
6
7
8
100
LINK
ACT
COM
IR/S
TX
RX
TX
RX
RTS
CTS
R
5
1
6
2
7
3
8
4
RELAY
FLEX
I/O
5
1
6
2
3
1
4
2
SWITCHED
12VDC
3
1
4
OVER
2 LIMIT
IR
7
3
8
4
Switched
12 VDC LEDs COM (Serial) LEDs IR/Serial LEDs
Relay LEDs
Flex I/O LEDs
Reset Button
(recessed)
Power LED
1
2
3
4
5
6
7
8
0
9
2–12"
(4–30 cm)
NOTE:
Numbers adjacent to LEDs correspond
to the like-numbered rear panel ports.
IR Receiver
IR Learning
Angle
and
Distance
LAN/
Network
LEDs
Figure 6.
IPCP 505 Front Panel
IR Learning Sensor
In most cases, Extron has already produced a driver file for controlling the projector, display,
or source device you plan to use. If a device driver file is not available, you can create your
own using Extron IR Learner software, the remote control of the projector or display, and the
IR learning receiver sensor on the IPCP, shown the figure above.
This receiver accepts infrared signals of from 30 kHz to 1 MHz. The IR remote control must
be pointed directly at the receiver for best results. The front panel diagram indicates the best
distances and angles at which to hold the remote control.
Reset Features
Reset button and LED
— Pressing this recessed button causes various IP functions
and Ethernet connection settings to be reset to the factory defaults. The green LED flashes
depending on the selected reset mode (see
and the reset modes table
Содержание IPCP 505
Страница 1: ...IPCP 505 IP Link Control Processor 68 2026 01 Rev C 03 20 User Guide IP Link Products ...
Страница 6: ......
