IPL EXP I/O Series • Hardware Features and Installation
9
Add the PL EXP expansion interfaces and program their ports.
Add touchpanels and set them up:
Upload the GUI configuration to the Global Scripter project.
Program functions, monitors, or schedules to the touchpanels and their
buttons.
Save the project.
Build and upload the system configuration to the control processor, expansion
interfaces, and other system devices.
Test and Troubleshoot
section starting on page 36 for an outline
of items to check during system troubleshooting).
Make adjustments to wiring or configuration as needed.
Network Communication Setup
Network setup is essential prior to configuration. Use the flowchart as a general guide to
setting up the expansion interface for network use.
Open the Toolbelt software from within
Global Configurator (GC Professional or
GC Plus mode) or as the stand-alone
application.
Start Device Discovery.
Toolbelt displays a list of all Extron control
devices connected to the network.
Using the MAC address, locate the desired
expansion interface in the list and select it.
Network Communication Setup
Connect the PC and the LAN port of the
expansion interface to the same network.
Apply power to all devices.
For each network interface (LAN),
use the Set IP feature in Toolbelt or use the
feature in the Toolbelt
Manage
>
Network
Settings
tab to enter the IP address and
subnet address. Then configure other
network settings as needed.
Figure 3.
Network Setup
NOTE:
If using 802.1X
security, see the
Extron
802.1X Technology
Reference Guide
(available
) and
the
Toolbelt Help
file for
additional details on
system setup.
Содержание IP Link IPL EXP 200
Страница 2: ...Safety Instructions...
Страница 6: ......