IN1806 and IN1808 Series Scaling Presentation Switchers • Operation
25
Powering Up
To power on the unit, connect the provided IEC power cable between the rear panel power
connector and an AC power source. During power-up, the following occurs in the order
listed:
1.
All backlit buttons (the input buttons and the
Logo
button) blink amber, red, and green
for approximately 15 seconds.
2.
The backlit buttons light steadily amber and remain lit for approximately 15 seconds.
On IPCP models, the RTS and I/O IPCP LEDs light and remain lit.
3.
The backlit buttons blink in sequence once, then turn off and remain unlit for
approximately 10 seconds.
4.
When the unit is ready for operation:
•
The button for the previously selected input lights steadily. If audio breakaway is not
enabled, one input button lights amber. If audio breakaway has been selected, the
selected video input button lights green and the audio input button lights red.
•
If input or output signals are present, the appropriate input and output LEDs light.
•
If a logo has been selected, the
Logo
button lights amber.
•
The green Mic and Volume LEDs light to the level previously set.
Selecting an Input
Press any of the input buttons on the front panel to select an input. The button lights amber.
You can also select inputs via SIS commands (see the
on
page 62) or PCS (see the
IN1806 and IN1808 Series PCS Help File).
NOTE:
The input buttons cannot select audio and video separately. To select breakaway
audio, you must use PCS or SIS commands.
Selecting a Logo
The front panel
Logo
button enables you to select a logo that has been stored in one of
logo memory slots 1 through 6 (IN1806) or 1 through 8 (IN1808) (7 or 9 through 16 can be
selected only via SIS commands or PCS) and to enable or disable displaying the selected
logo on the screen.
To select a logo to display:
1.
Press and hold the front panel
Logo
button until the input buttons representing the slots
containing logos light green (approximately 3 seconds). The buttons remain lit for about
15 seconds.
2.
Press the lit button for the desired logo. The
Logo
button lights amber and the logo
stored in the selected slot is displayed on the screen.
To deselect a logo
, press the lit
Logo
button. The button turns off and the logo disappears
from the screen.
NOTE:
To configure logo key effects (such as RGB keying, alpha keying, and so
on), you must use PCS (see the
IN1806 and IN1808 Series Help File
).