FPC 6000 • Operation
25
Menu Buttons
The FPC 6000 has five screens: the
Connect
(login) screen and four main screens. These are
Ties
,
Status
,
I/O
Info
, and
Customize
. Five menu buttons on the left side of the screen
on the previous page) allow you to navigate to the desired screen by
pressing the appropriate button. These buttons are available on all FPC 6000 screens, and the
currently selected button has a colored edge.
Input Buttons
The screen has two blocks of numbered buttons. The buttons on the left correspond to the
matrix switcher inputs. The buttons on the right correspond to the matrix switcher outputs.
Before you make any ties, the input buttons (
) have a gray rectangle in the top right corner.
The number in that rectangle corresponds to the number of the input on the switcher. When an
input is selected, the button lights up.
Input
#
Input
#
Input
#
Figure 24.
Selected and Unselected Inputs
The button also contains the name of the input. By default, this is
Input
XXX
, where
XXX
is
the same as the number in the top right corner of the button. Buttons can be renamed using
Simple Instruction Set (SIS) commands (see the matrix switcher user guide for instructions) and
through the PCS.
The FPC 6000 screen shows 20 inputs at a time. Use the scroll bar to the right of the inputs to
navigate through all the inputs that are available with your matrix switcher.
NOTES:
•
When selected, the button lights up.
•
After 30 seconds with no front panel activity, all buttons time out.
•
After 3 minutes with no front panel activity, the panel enters power saving mode. The
touchpanel becomes active again when it detects motion in front of the screen. (This
timeout can be changed.)
Output Buttons
Before you make any ties, the output buttons (
E
) have a gray rectangle in the top right
corner. The number in that rectangle corresponds to the number of the output on the switcher.
When an output is selected, the button lights up. If the output is tied to an input, then the
corresponding input button also lights up.
Output
#
Output
#
Output
#
Figure 25.
Selected and Unselected Outputs
The button also contains the name of the output. By default, this is
Output
XXX
, where
XXX
is
the same as the number in the top right corner of the button. Buttons can be renamed using
SIS commands (see the matrix switcher user guide for instructions) and through the PCS.
The FPC 6000 screen shows 20 outputs at a time. Use the scroll bar to the right of the outputs
to navigate through all the outputs that are available with your matrix switcher.
The button also provides information about the mute status of the output (see
figure 24
figure 25
Содержание FPC 6000
Страница 6: ......
Страница 8: ...FPC 6000 Contents viii ...
