DVS 605 • Product Configuration Software
83
To automatically adjust these settings, perform one of the following:
•
Click the
Auto-Image
,
on the previous page)) to perform a
one-time Auto-Image.
•
Click the
Auto-Image & Fill
) to perform a one-time Auto-Image and fill
the entire video output (ignores aspect ratio setting).
•
Click the
Auto-Image & Follow
button (
) to perform a one-time Auto-Image and to
maintain the aspect ratio of the input signal (ignores aspect ratio setting).
Picture Controls panel
The
Picture Controls
panel shows adjustable image settings for the selected input
displayed in the
Main
window or the
PIP
window.
Figure 57.
Picture Controls Panel
Select the
Main
Window
or
PIP
Window
radio button as applicable.
To adjust the picture settings, click and drag the associated slider for any image setting
(brightness, contrast, color, tint, or detail) to the desired value.
Alternatively, enter a value within the field associated with the image setting, or click the
Up
and
Down
arrows to change the value in the field.
Overscan panel
Overscan mode zooms and crops SMPTE inputs to mask edge effects and ancillary data
common in broadcast signals. Issuing an Auto-Image with overscan enabled, runs an Auto
Phase routine (YUV and RGB only) and centers and sizes the input according to table
values.
Figure 58.
Overscan Section
For each input signal type, select a value from the corresponding drop-down menu.
NOTE:
Setting a value of
0%
disables overscan for the corresponding input format.
57
58
Содержание DVS 605
Страница 6: ......