DVS 605 • Operation
13
Powering Up
When applying power to the DVS 605, the unit undergoes a start-up self-testing sequence
(see image below) and then the LCD displays the default display cycle.
Default Display Cycle
When in use but not in any menu mode, the LCD screen defaults to cycling through
the input and output configuration currently installed. The displayed content may vary,
depending on the input video signal type (see figure 8 for a typical default display cycle).
13 sec.
Apply
Power
EXTRON
DVS 605
XX
11 sec.
Last active input
button remains lit.
16 sec.
60-1059-
xx
FW v1.
xx
All input LEDs flash
(red then green).
1
2
3
4
5
PIP
EXTRON
ELECTRONICS
1
2 sec.
2
sec.
Default Display Cycle
IN RGBHV
#1 640x480
IN 31.47 kHz
#1 59.94 Hz
OUTPUT
720p@60
2 sec.
2 sec.
Display screen
starts blank.
Note:
Times shown are approximate.
Figure 8.
Typical Default Display Cycle
The default display cycle shows the scaler output rate and refresh rates for the currently
selected input.
DVS 605 Menu System — Configuration and Adjustments
Scaler configuration and adjustments can be performed by using the embedded web pages
(see
on page 94), the Extron Simple Instruction Set (SIS)
of commands (see
starting on page 61, or the front panel controls and the menus
displayed on the LCD screen. These menus are used primarily when the scaler is first set
up. Details of each of the menus are on the following pages after the main flow chart.
Menu Navigation Using Front Panel Controls
Menu button
— Press the
Menu
button to activate menus and scroll through the eight main
menus.
Next button
— Press the
Next
button to move between the submenus of a selected main
menu item.
Adjust
(
[
,
{
)
knobs
— In configuration mode, rotate the horizontal
Adjust
(
[
) knob
and vertical
Adjust
(
{
) knob to scroll through submenu options and to make adjustment
selections (see the flowcharts in this section for explanations of knob adjustments).
8
Содержание DVS 605
Страница 6: ......