DVS 510 Series • Operation
44
Output Sync Mute
This function mutes all video and sync outputs, placing the display device in a power
save mode. Output sync mute is available only via SIS commands (see the
commands on page 59).
NOTE:
Individual outputs cannot be muted by this command. With the output sync
mute enabled, all analog and digital outputs are simultaneously disabled.
Overscan Mode
This function allows you to set a default overscan of 0%, 2.5%, or 5% to apply to SMPTE
input rates (NTSC, PAL, 480p through 1080p). When the overscan mode is
not
set to 0%
and an auto-image is performed on a low-resolution or DVI input, the DVS uses the default
values for input sizing and centering instead of performing a complete auto-image.
For YUV Auto and RGB inputs, pixel phase is included in the auto-image, regardless of the
current overscan setting.
The overscan mode setting is adjusted per input type (composite, S-video, RGBcvS,
YUV Auto, RGB, and DVI) using SIS commands (see the
commands on
page 66).
Using the Optional IR 904 Remote Control
The optional hand-held IR 904 Remote Control provides a convenient means of remotely
performing many of the functions that are also available through the front panel, SIS
commands, the Windows-based control software, or the embedded web pages. The DVS
responds to commands from remote control as if the corresponding button were pressed
on the front panel or the corresponding SIS command or software selection were entered.
The IR receiver port on the front panel is located to the left of the CONFIG port. It receives
signals from the remote control if they are sent from within a 40-degree arc to the right or left
of direct line of sight between the remote control and the scaler IR sensor, and from no more
than 30 feet (9 meters) away.
DVS 510
DIGITAL VIDEO SCALER
MENU
NEXT
DETAIL
ZOOM
/PAN
BRIGHT
/CONT
COLOR
/TINT
SIZE
POSITION
PIP
ON/OFF
PIP
SWAP
CONFIG
IR
MAX
MID
MIN
10
1
2
3
4
6
7
8
9
5
ADJUST
VOLUME
PICTURE CONTROLS
PIP
INPUTS
DVS 510 Series Scaler
40
40
30
’ (9.1 m)
maximum
IR 904 Remote Control
PIP
VOLUME
4
3
2
1
IR 904
REMOTE
ON/OFF
SWAP
INPUT SELECTION
AUTO
IMAGE
POSITION
SIZE
COLOR
CONT
DETAIL
ADJUST
8
7
6
5
10
9
PAN
ZOOM
A/V
MUTE
VIDEO
MUTE
AUDIO
MUTE
IMAGE ADJUSTMENTS
+
-
TINT
+
-
+
-
BRIGHT
FREEZE
+
-
+
-
Figure 25.
Area for Remote Signal Reception
