Extron electronics DVS 510, Руководство пользователя

Страница: 118 / 128

DVS 510 Series • Reference Information 110
MBD 249
2U Rack Mounting
Bracket (Pre-attached)
Figure 47. Rack Mounting a DVS 510 Scaler
Tabletop Use
To set up the unit for tabletop use:
1. Remove the eight screws to detach the mounting brackets from the sides of the unit.
2. Attach one of the provided self-adhesive rubber feet to each corner of the bottom of the
unit.
Button Labels
The DVS 510 is delivered with button caps pre-labeled for your convenience. However, you
can replace these labels with your own button labels, if desired.
Page 113 contains blank
button labels. If desired, print the page and cut the labels out, write button information in
each button area as desired, and insert them behind the transparent button caps. You can
also create labels using the Button Label Generator software, provided with the DVS on the
Extron software DVD.
Replacing Button Labels
The button assembly consists of a clear lens cap, the button label, and a white diffuser (see
figure 48 on the next page).
To replace a button label:
1. Make new labels as needed, using either the blanks on page 113 or the Button Label
Generator software, and cut them out.
2. Remove the button assembly by inserting a small, flat-bladed screwdriver between the
button base and the diffuser to gently pry the button assembly off the button plunger
(see
figure 48 ,
2
).