Extron electronics DVI 201xi TX, Руководство пользователя, Страница: 33 / 44

DVI 201xi Tx • Configuration and Operation
3-5
Using pass-through mode with DDC routed to the
remote display
N Although DDC can be routed to the remote display,
there may be instances when the signals may become
corrupted or weak. In those cases, the source device may
be unable to boot up correctly.
1 . Set the EDID Minder switch to the Off (Down)
position and the Remote DDC switch to the
On (Up) position (see the figure at right). The
position of the Default EDID switch is not
relevant.
2 . Connect the source device to the transmitter
input.
3 . Connect the display device to the receiver
output and, if required, the local monitor to the transmitter
output.
4 . Connect the transmitter to the receiver with the two
twisted pair cables.
Transmitter port 1 connects to receiver port 1 •
Transmitter port 2 connects to receiver port 2 •
5 . Power on the remote display.
6
. Boot up the source device. The source will boot with the
resolution and refresh rate of the remote display.
N Because the remote display is the source of EDID, it
must be powered on before the source device is booted.
7 . Power on the local monitor, if required.
N If used, the local monitor must be capable of handling
a resolution equal to or greater than that of the remote
display.
ON
1 2 3
ON
OFF
DEF
AUL
T EDID
EDID MINDER REMOTE DDC