Extron electronics DSC HD-HD 4K Plus A Series, Руководство пользователя, Страница: 47 / 92

Power Save Mode
In power save (standby) mode, all non-essential hardware is shut down in order to
conserve power. The default state for power save mode is Off.
• To enable power save mode, enter the
Power Save ON
SIS command (see the
Power
Save Mode commands
on page 58). While the DSC is in power save mode, the
Status LED (power and signal) blinks amber slowly.
•
To exit power save mode, do one of the following:
•
Enter the
Power Save OFF
SIS command.
•
Press any front panel button (if the front panel is locked, this method does not
work).
•
Cycle power to the unit.
NOTE: Many functions in the PCS software, such as backup and restore, are not
accessible while the unit is in power save mode.
Presets
A preset is a set of input parameters that are either saved by you or automatically by
the DSC as a file in DSC memory. Saved presets can be recalled and their settings
implemented at any time. A preset saves time by enabling you to apply a group of settings
to the DSC at one time. The DSC HD-HD 4K Plus A Series scalers have two types of
presets: Auto Memories and input presets.
Auto Memories
The DSC has 32 memory locations in which the current input configuration and picture
control values are automatically stored as a preset, when Auto Memory is enabled. An
Auto Memory preset is recalled when an identical input resolution and rate is applied to
the input.
Auto memories can be enabled using the OSD (see the
Auto Memory item
on
the
Advanced
submenu on page 34), by SIS commands (see the
Auto Memories
commands
on page 56), and the PCS software (see the program help file).
The following information is stored in an Auto Memory preset:
• Contrast • Horizontal image position
• Brightness • Vertical image position
• Detail • Horizontal image size (width)
• Active pixels (H Active) • Vertical image size (height)
• Active lines (V Active)
DSC HD-HD 4K Plus A Series • Operation 39