Extron electronics 60-1017-0200, Руководство пользователя

Страница: 21 / 60

2-11
TLP 350CV • Installation and Operation
Mounting the TLP 350CV
W The flanged edges of the the trim ring are sharp. Exercise caution when
the enclosure is not in the table to prevent personal injury.
C
The trim ring edges can easily be nicked or bent. Exercise caution when
handling and mounting the enclosure.
1. If table clamps are installed, remove them from both sides of the enclosure.
2. Remove the edge grommet protecting the corners of the trim ring and the
plastic film on the finished surfaces.
C Do not use isopropyl alcohol or other solvents to clean the Cable Cubby.
Strong solvents may ruin some finishes.
3. While feeding the cables hanging from the underside of the enclosure,
carefully lower the Cable Cubby enclosure into the cutout to test the fit. If
necessary, remove the enclosure and use a file or rasp to enlarge or smooth the
edges of the opening (figure 2-9).
Table
Clamp
Both Sides
PC
LAP
TOP
DVD
DOC
CA
M
AUX
ILIA
RY
DISP
LAY
ON
DISP
LAY
OFF
AUT
O IM
AGE
VOL
UM
E
VOL
UM
E
Extr
on
Figure 2-9 — Cable Cubby TLP 350CV, installation view
4. Install the table clamps onto the pins on the side of the enclosure at a height
which allows the clamp to reach the underside of the tabletop.
5. Snugly tighten the screws on the table clamps to secure the enclosure to the
bottom of the table.
C
Do not overtighten the screw clamps. Overtightening can bend the
horizontal flange of the clamp.
6. Tighten the wingnuts to lock the clamps in position.