Installation and Operation, cont’d
TLP 350CV • Installation and Operation
2-10
Installing the Shelf Assembly
From the underside of the Cable Cubby:
1.
From the underside of the Cable Cubby, push the AAP shelf assembly
into position at the desired elevation. Choose the adjustment height that
provides enough clearance to allow the lid to be closed without contacting the
connectors.
N
If the AAP shelf assembly does not slide easily into the cubby, loosen the
AAP mounting nuts. Retighten the AAP mounting nuts once the AAP shelf
assembly is installed in position.
COMPUTER
AUDIO
Philips Head Screws
(secures AAP Shelf
Assembly)
Tighten down
AAP Nuts.
Push assembly through
bottom of enclosure.
Large holes
provide tool
access to fasten
rear brackets.
2
1
3
Figure 2-8 — AAP shelf assembly installation
2.
With the AAP assembly at the desired location install two Phillips head
screws on each end of the shelf brackets in the front and two in the rear of the
enclosure as shown in figure 2-8. The larger holes in the enclosure provide
tool access for the rear bracket screws.
3.
Tighten the nuts that secure the AAP plates to the shelf brackets.
Содержание 60-1017-0200
