Extreme Networks Summit WMScanner, Руководство пользователя, Страница: 9 / 217

Summit WMScanner Users Guide
7
3 Select Treat Drivers Signed by Microsoft the Same as Those Signed by Others and then click Properties .
4 On the settings tab, select Enabled .
5 Open a command window, select Run As Administrator, and run the Group Policy update utility,
GPUpdate.exe, to ensure that the settings are updated on the target system. Ensure that the success
message is shown.
Driver Installation
CAUTION
If the WLAN card has not been previously installed on the computer, then it is recommended to straight away install
the measurements adapter without installing the card manufacturer’s driver. Non-administrative users must have the
write permissions to the directory where the drivers are installed.
For Measurements, use recent Atheros 802.11 chipset LAN cards
●
Netgear 802.11a/b/g wireless PC card (model #WAG511)
●
Cisco a/b/g Cardbus Adapter (model #AIR-CB21AG-A-K9)
●
Ubiquiti Networks SuperRange Cardbus
●
D-Link DWA 645 Rangebooster N 650 Notebook Adapter
●
AirPcap 802.11 Wireless Packet Capture Card
Follow the instructions below for installing measurements driver for Summit WMScanner.
Driver Installation Instructions:
1 Insert the network adapter into your computer's PCMCIA slot.
2
If the hardware update wizard pops up, press cancel. Double click on Driver Setup.exe present in the
Summit WMScanner\Help\WLAN drivers\ directory.
3
The RF Measurement Driver Installer dialog box appears. Select Next .