2 Using the handle in the bottom of the power supply module, pull the power supply from the system
while pushing the green latch in the direction indicated in the image.
Figure 7: Removing a Power Supply Module
Replacing a Power Supply
The appliance has two power supplies, supplying hot-pluggable power redundancy. The system
distributes the power load across both power supplies to maximize efficiency. When a power supply is
removed with the system powered on, the full power load is picked up by the remaining power supply.
Note
The system requires one power supply to operate normally. Remove and replace only one
power supply at a time in a system that is powered on.
Note
The system ships with just one power supply and you have the option to purchase the
additional power supply (Ordering Part No. 30522 WS-PSI-C5215-750W-01).
Each power supply has a single bi-color LED to indicate power supply status, as described in the
following table:
Table 6: Power Supply Status LED Indicator Patterns
LED Pattern
Power Supply Condition
Green
Output on and OK
Off
No AC power to all power supplies
1Hz Blinking Green
AC present / Only 12VSB on (PS off) or PS in cold redundant state
Amber
AC power cord unplugged or AC power lost. With a second PS in parallel
still with AC input power
1Hz Blinking Amber
Power supply warning events where PS continues to operate — high temp,
high power, high current, slow fan
Installation Process
ExtremeWireless™ Appliance C5215 Installation Guide
14
