Extreme Networks ExtremeRouting SLX 9850-4, Руководство по установке оборудования

Страница: 63 / 158

10. Plug the other end of the cable into the power source.
NOTE
Do not connect the device to the network until the IP addresses are
configured.
For information about power supply LED patterns, refer to Interpreting power supply module LEDs on page 80.
For NEBS-compliant installation with AC and DC
For the NEBS-compliant installation of the Extreme device with AC and DC systems, use a copper ground wire of at least 2 American
Wire Gauge (AWG). The ground wire should have an agency-approved crimped 2-hole lug (provided with the device) attached to one
end, with the other end attached to building ground.
The connector must be crimped with the proper tool, allowing it to be connected to both ground screws on the enclosure. Before
crimping the ground wire into the provided ground lug, ensure the bare copper wire has been cleaned and antioxidant is applied to the
bare wire.
To ensure adequate bonding when attaching the ground lug, a minimum of 55-65 in-lbs of torque is required to be applied to the
mounting hardware used to attach the ground lug.
All bare grounding connection that points to the Extreme device shall be cleaned and coated with an anti-oxidant solution before
connections are made.
Establishing a serial connection
To establish a serial connection to the console port on the device, complete the following steps.
1. Verify that the device is powered on by verifying that all power LED indicators on the management, interface, power supply, and
fan modules display a steady green light.
Establishing a serial connection
ExtremeRouting SLX 9850-4 Hardware Installation Guide
9035474-02 Rev AA 63