Removing and Installing the Front Bezel
12 of 31
LED Pattern
Power Supply Condition
1Hz blinking green
AC present / Only 12VSB on (PS off) or PS in cold redundant state
Amber
AC power cord unplugged or AC power lost. With a 2nd PS in parallel still with AC input power
1Hz blinking amber
Power supply warning events where PS continues to operate — high temp, high power, high
current, slow fan
Amber
Power supply critical event causing a shutdown, failure, OCP, OVP, fan fail
2Hz blinking green
Power supply firmware updating
Removing and Installing the Front Bezel
The engine comes with an optional front panel bezel that you can attach to the
front of the chassis by snapping the bezel onto the chassis handles. A key lock
allows you to lock the bezel in place so that front panel controls cannot be used.
You can still monitor system status indicators with the bezel in place.
Removing the Front Bezel
To remove the front bezel:
1. Unlock the bezel if it is locked.
2. Remove the left end of the front bezel from rack handle.
3. Rotate the front bezel counterclockwise to release the latches on the right end from
the rack handle.
Installing the Front Bezel
Note: Before installing the bezel, you must install the rack handles. See
Installing the Engine into a Rack
.
To install the front bezel:
1. Lock the right end of the front bezel to the rack handle.
2. Rotate the front bezel clockwise till the left end clicks into place.
3. Lock the bezel, if needed.
Installing the Engine into a Rack
A rack mounting kit and installation guide are included with the engine. The rack
mounting kit allows you to install the engine into a four-post rack cabinet. Refer
