Label
Color and Status
Description
Green (steady)
The second power supply (in either PSU1 or PSU2) is present
and operating normally as a redundant power supply (RPS).
Fan
Amber (steady)
A fan module has been removed.
Amber (blinking)
A fan module has failed.
Green (steady)
All fan modules are operating normally.
100 Mbps/1 Gbps/10 Gbps RJ-45 port LED state indicators
This section describes the RJ-45 copper port LED state indicators by color and fluctuation cues. The
up arrow on the left indicates the top port; the down arrow on the right indicates the bottom port.
Table 16: 100 Mbps/1 Gbps/10 Gbps port LED state indicators
Label
Color and Status
Description
Link/Act
Off
There is no transceiver present and the port is administratively
enabled.
Amber (steady)
The port has a link in 100 Mbps mode.
Amber (blinking)
The port has a link and data activity in 100 Mbps mode.
Green (steady)
The port has a link in 1 Gbps mode.
Green (blinking)
The port has a link and data activity in 1 Gbps mode.
Green (slow blinking)
The port is administratively disabled.
Blue (steady)
The port has a link in 10 Gbps mode.
Blue (blinking)
The port has a link and data activity in 10 Gbps mode.
SFP and SFP+ port LED state indicators
This section describes the transceiver port LED state indicators by color and fluctuation cues. These
ports use the LED on the left side of the port (
Link/Act
) to indicate whether or not the link is
established and if a transceiver is present and active.
The LED on the right side of the port (
In Use
) indicates the operating speed of the transceiver.
Table 17: SFP/SFP+ port LED state indicators
Label
Color and Status
Description
Link/Act
Off
There is no transceiver present and the port is administratively
enabled.
Amber (steady)
The port is actively transmitting, but there is no link. This
indicates a local fault.
Table continues…
Installing the Virtual Services Platform 7200 Series
March 2020
Installing the VSP 7200 Series
38
