2
4. Connect the velcro on roof corners to the
velcro on the corners of the marquee legs.
8. Lift all four upper connectors until pin locks
into position. Stand on the foot plate and lift
with two hands until you hear a ‘click’.
7. Ensure there are no trip hazards. Walk
backwards and open the frame fully.
11. Extend the opposite side’s legs and repeat
step 10.
Once marquee is set up, refer to
SECURING
YOUR MARQUEE.
2. Gripping the lower centre set of truss bars
(shown), expand the frame by roughly 3/4s.
1. Remove all your items from the packaging
and clear a safe area.
5. Fit the peak of the roof to the centre pole(s)
of the marquee & tighten the ferrule toggle.
9. Ensure the protective flap is resting over
the truss connector. This will protect the roof
from wear. Attach the roof straps by looping
them around the frame and buckling the clip.
Tighten the strap as needed.
3. Fit the roof to the frame.
6. Refer to LIFT HERE sticker. Grasp marquee
truss bars.
10. Extend one full side of marquee legs.
Using your foot, stand on the marquee foot
plate, release the button on the middle leg
connector and extend the legs to desired
height.
3MX6M MARQUEE SETUP
REFER TO NEXT PAGE >>
SETUP INSTRUCTIONS
Please read instructions completely before setting up your marquee. Make sure you have all the components identified on the Parts List.
Recommended procedure below. For safety reasons it is recommended that 2 persons set-up / pack down any marquee.
