Exmark Z Turf Equipment Z-SPRAY, Руководство оператора

Страница: 60 / 68

Storage
Storage
Extended or Winter Storage
To help protect the pumps from freezing
temperatures make sure the unit is free of all caustic
chemicals and residue.
Spreader Cleaning
Perform all the steps in Cleaning the Spreader in
the Operation section.
Sprayer Cleaning
1. Perform all the steps in Cleaning the Sprayer in
the Operation section.
2. Add a rust inhibiting, non-alcohol based, RV
antifreeze solution to the system. See label to
ensure the product will provide appropriate
protection for the climate.
A. Make sure the sprayer is empty and let the
pump run until the nozzles are spraying air.
B. Pour 2 gallons (7.6 L) of RV anti-freeze into
the sprayer tank.
C. Run the pump to distribute the anti-freeze
mix throughout the system.
D. Set the wide spray lever to the “ON” position
to begin spraying. Allow the antifreeze to
circulate through sprayer and nozzles. Do the
same for the narrow spray. Remove the wand
from its holder, point it in a safe direction,
and squeeze the spray wand trigger. Return
the wand to its holder.
Note:
Do Not allow all the mix to spray
out of the tank. Keeping some antifreeze in
the pump, valves, and hoses will help prevent
rusting and damage caused by moist air that
may be trapped in the system.
E. Turn off the spray control lever and the spray
pump switch.
General Cleaning
Follow all instructions in the Maintenance and
Cleaning sections.
Refer to the Engine Owner’s manual for proper
storage of the engine.
Battery Storage
Disconnect the battery and place on a trickle charger
for a few hours once per month.
60