Maintenance
2.
Remove left and right belt shields on deck and
lower the deck to inspect deck drive belt.
3.
Check under machine to inspect the pump drive
belt.
Note:
No adjustments are required for belt
tension.
Lubricate Grease Fittings
Note:
See chart for service intervals.
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Lubricate fittings with one to two pumps of
NLGI grade #2 multi-purpose gun grease.
Refer to the following chart for fitting locations
and lubrication schedule.
Lubrication Chart
Fitting
Locations
Initial
Pumps
Number of
Places
Service
Interval
1. Deck and
Pump Idler
Pivot
1
2
50 hours
2. Front
Caster
Axles
(S- and
E-Series
Only)
1
2
25 hours
2. Front
Caster
Axles
(X-Series)
1
2
Yearly
g014848
Figure 64
Lubricate Caster Wheel Hubs
(X-Series Only)
Service Interval: As required
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
g006115
Figure 65
1.
Seal guard
2.
Spacer nut with wrench
flats
2.
Remove caster wheel from caster forks.
3.
Remove seal guards from the wheel hub.
4.
Remove one of the spacer nuts from the axle
assembly in the caster wheel. Note that thread
locking adhesive has been applied to lock the
spacer nuts to the axle. Remove the axle (with the
other spacer nut still assembled to it) from the
wheel assembly.
5.
Pry out seals, and inspect bearings for wear or
damage and replace if necessary.
6.
Pack the bearings with a NLGI grade #1
multi-purpose grease.
7.
Insert one bearing, one new seal into the wheel.
Note:
Seals (Exmark P/N 103-0063) must be
replaced.
8.
If the axle assembly has had both spacer nuts
removed (or broken loose), apply a thread locking
adhesive to one spacer nut and thread onto the
axle with the wrench flats facing outward. Do
Not thread spacer nut all of the way onto the end
of the axle. Leave approximately 1/8 inch (3 mm)
from the outer surface of the spacer nut to the
end of the axle inside the nut.
9.
Insert the assembled nut and axle into the wheel
on the side of the wheel with the new seal and
bearing.
63
Содержание Radius E Series
