14
FIGURE 2
MOTION CONTROL POSITIONS
By moving both levers an
equal
amount forward or back from the neutral position
the machine can be caused to move forward or backward in a straight line.
Movement of the
left lever forward
will cause the
left drive wheel
to rotate in a
forward direction. Movement of the
right lever forward
will cause the
right
drive wheel
to rotate in a forward direction. To
stop
forward travel, pull the
levers back to the neutral position.
To
turn left
while moving forward, move the
left lever
back toward neutral to
slow the left drive wheel. To
turn right
while moving forward, move the
right
lever
back toward neutral to slow the right drive wheel.
To make a
zero turn
to the
left
, pull the left lever back beyond neutral while
holding the right lever slightly ahead of neutral.
To make a
zero turn
to the
right
, pull the right lever back beyond neutral while
holding the left lever slightly ahead of neutral.
Pulling
the
levers back
from the neutral position will cause the respective drive
wheels to rotate in a
reverse
direction (spring tension can be felt when moving
into reverse from neutral).
To turn to the left while backing, move the left lever forward toward neutral. To
turn to the right while backing, move the right lever forward toward neutral.
CAUTION
POTENTIAL HAZARD
♦
Machine can spin very rapidly by positioning one lever
too much ahead of the other.
WHAT CAN HAPPEN
♦
Operator may lose control of the machine, which may
cause damage to the machine or injury.
HOW TO AVOID THE HAZARD
♦
Use caution when making turns.
♦
Slow the machine down before making sharp turns.
3.1.3
Tracking Adjustment Knob: Located under the seat on the LH pump control link.
Rotating this knob allows fine tuning adjustments so that the machine tracks straight
with the drive levers in the full forward position.
Stop machine and wait for all moving parts to stop. Engage park brake. Unhook
seat latch and tilt seat forward to gain access to the tracking knob. Rotate the knob
counter-clockwise (as viewed from the rear of the machine) to cause the machine
to track more to the right and clockwise to cause the machine to track more to the
left. Adjust in quarter-turn increments until the machine tracks straight. Check that
the machine does not creep when in neutral with the park brakes disengaged.
IMPORTANT: Do not rotate the knob too far, as this may cause the machine
to creep in neutral. Refer to section 4.2.10 for control linkage adjustment.
Содержание Lazer ZCT
