Page 1 of 5
109-4291 Rev. A
Loose Parts
Note:
Use the chart below to verify that all parts have been shipped.
109-2996
Dealer Literature Pack
Part #
Description
Qty
Use
323-9
13-2840
3296-39
3247-4
109-4492
Cap Screw, Hex 3/8-16 x 1-3/4
Key, Square
Nut, Nyloc, 3/8-16
Set Screw, 3/8-16
Washer, Special
1
1
1
1
1
Installing the PTO Shaft
103-1309
Warranty Registration Form
1
Fill out and return to Exmark
109-1303
Literature Pack
Part #
Description
Qty
Use
109-4290
Manual, Operator & Parts
1
Read and view before operating machine
WARNING
POTENTIAL HAZARD
♦
Operating a FrontRunner tractor without an
approved Exmark front mount attachment
increases the possibility of forward tip over.
WHAT CAN HAPPEN
♦
Tip-over could cause serious injury or death.
HOW TO AVOID THE HAZARD
♦
When operating a FrontRunner tractor without
an approved Exmark front mount attachment,
observe the following:
9
Limit operation to minimum required to
install a different front mount attachment.
9
Minimize speed and use extreme caution.
9
Only operate on a flat level surface.
9
Do not operate up or down a trailer ramp.
9
Avoid sudden acceleration or deceleration.
Uncrate Deck
1. Remove top and sides of crate from base.
2. Remove straps securing front frame and deck to
crate.
Lowering the Discharge Chute
1. The discharge chute is shipped in the “up”
position.
2. Slightly loosen the two bolts enough to rotate
the discharge chute to the down position.
(See Figure 1)
3. Snug tighten the two bolts just enough to cause
some drag when rotating the chute.
FIGURE 1
Installing the PTO Drive Shaft
1. Cut zip ties securing drive shaft to crate.
2. Remove tape from shaft and key.
3. Insert square key on the input shaft on the
gearbox and then slide shaft into the PTO yoke
until it contacts washer. (See Figure 2)
FRONTRUNNER
®
52” & 60” DECK
SETUP INSTRUCTIONS
For Serial Nos. 600,000 and Higher
